|
By: batotoy (offline) Friday, November 20 2009 @ 02:59 PM ICT (Read 1964 times)
|
|
|
batotoy
|
ei! guys, wanna need some advice what will i do for my raider 150, what is the best setting.
the cutting of the block or the Zero gasket
i'll waiting for you suggestion,
thanks...
Batotoy
Ahente! ! !
|
Newbie
Group Comfort
Level:: 0
Registered: 11/19/09
Posts: 1
Location: Balayan,Batangas,
Philippines
|
|
|
|
|
|
|
|
By: Richard (offline) Friday, November 20 2009 @ 04:43 PM ICT
|
|
|
Richard
|
We are not sure what you mean, but if you want to ask what is better. Cut the into the cylinder head to get a higher compression ratio or try to reach this higher compression ratio by using special racing gaskets?
I will recommend go for a good set of racing gaskets.
|
Active Member
Group Comfort
Level:: +10
Registered: 10/01/07
Posts: 236
|
|
|
|
|
|
- 
My raider 150 for stock racing
