Reduce the Risk of Leaning in Cornering
When motorcycle departs the vertical, its tires have to work a lot harder. There is some ac/deceleration they mush deal with. The turning arc adds sideways loads and a small amount of sideways slip. The harder you lean, the more work for the tire. If you're smooth, the tire has a slightly easier job, if you're not, it has to absorb all of your jerky inputs. The problem is that diminished overall grip creates a fragile equilibrium that is easy to upset.
Motorcycles have to lean over into corners to change direction, but there are ways to minimize risk. Even if you cannot actually reduce the actual angle, you can dramatically reduce the amount of time you sped at that angle. Here's how.
Riders are afraid. The open chasm of a valley or a wall of hard rock on the outside of a mountain road corner causes your brain to react. You instinctiveely want to turn quickly away from the danger. What this leads to is a well understood problem called turning in too early. That leads to an early apex (the point where you come closest to the inside of the corner) and that, further, leads to another troubling problem, you exit really wide requiring either a second steering input or interrrupted acceleration. This approach happens to require the motorcycloe to sit at a high lean angle for a long time and you may not be able to open the throttle early and stabilize the motorcycle either. It's a high risk situation. Fortunately, it's avoidable.
What you need to do, is tear your eyes off the perceived danger and look where you need to go next. This calms your nerves. It will also allow you to the run deeper into the corner before you initiate a change of dicretion. In the process, you will see further into the corner, which is better for your nerves and safety.
But look at what happens next. Because you start turning later, you have to make a sharper steering input. This sounds higher risk but what actually happens is that you use a high lean angle for a short instant and then you're already on a smoother, wider exit line. This and the fact that you can see further allows you to immediately open the throttle which brings stability. Opening the throttle also creates more cornering clearance as the motorcycle lifts to accomodate this input – fewer hard scrapes to interrupt you. The lifting of the motorcycle means less lean angle and less risk. It gets better. This line leads to a later apex which leads to an exit where you don't run quite so wide. So you're unlikely to wanter into oncoming traffic or off the road.
Remember that it feels very different from an early apex. You go in significantly slower and that can feel like you're not on the pace. But you come back on the throttle so much earlier, that your exit is usually much faster and you are usually going quicker overall. That's why it's called slow in fast out. Another reason why it feels slower is because your perception of the danger you're in, whether form the visuals or from lean angle, is lower. You feel safer and more stable.
How to practise this? Wait a little bit before you turn the motorcycle into a corner. This is easy to do at the racetrack. On the road, start be waiting an extra 10 to 20 centimeters and then extending that distance slowly as you get used to it. Can you go too deel? Of course and you'll realize it when that happens easily long before it puts you at risk. If you're trying this on a public road, remeber, as always, to check your mirrors -riders turning in early may be fqaster than you in the first part of the corner and then much slower afterwards.